BrightSign XD230 Guia do Utilizador descarregar pdf (Página 70)

Connector Volume: Changes the audio settings of a specific connector.

• Set volume: Specifies the volume level. Select the Analog, HDMI, and SPDIF connector in the dropdown list and

enter a volume value between 0 and 100 in the field.

• Increment volume: Specifies how much the volume level increases with each interaction. Select the Analog,

HDMI, or SPDIF connector in the dropdown list.

• Decrement volume: Specifies how much the volume level decreases with each interaction. Select the Analog,

HDMI, or SPDIF connector in the dropdown list.

• Mute: Turns the connector audio output off. Use the checkboxes to select among the Analog, HDMI, and SPDIF

connectors.

• Unmute: Turns the connector audio output on. Use the checkboxes to select among the Analog, HDMI, and SPDIF

connectors.

Zone Volume: Sets the volume for a zone. Note that the Connector Volume command takes precedence over the Zone

Volume command when both are used in a presentation.

• Set: Specifies the zone to which this command applies. Enter a volume value between 0 and 100.

• Increment: Specifies how much the volume level increases with each interaction. Use the dropdown menu to

select the zone to which this command applies.

• Decrement: Specifies how much the volume level decreases with each interaction. Use the dropdown menu to

select the zone to which this command applies.

Send: Sends information using the following methods:

• UDP: Sends a command to the device using UDP protocols.

• Send string (EOL): Sends the specified string to the specified serial port. This command adds a carrier return at

the end of the string.

• Serial string (no EOL): Sends the specified string to the specified serial port. This command does not add a

carrier return at the end of the string.

• Serial byte: Sends the specified byte to the specified serial port.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 132 133

Sem comentários

BrightSign XD230 Guia do Utilizador Página 70